-
Content Count
1,881 -
Joined
-
Last visited
-
Days Won
5
Reputation Activity
-
Defective got a reaction from NZXD in XB GS bonnet on an E series.
http://i204.photobucket.com/albums/bb160/H2Micr0/BenJs%20EB%20Ghia%20Wagon/AJR%20Wheels/WagSpeedyCheetahs12_zpsdb52a70c.jpg"
-
Defective got a reaction from NZXD in XB GS bonnet on an E series.
http://i204.photobucket.com/albums/bb160/H2Micr0/BenJs%20EB%20Ghia%20Wagon/AJR%20Wheels/WagSpeedyCheetahs12_zpsdb52a70c.jpg"
-
Defective reacted to n00bus m@x1mus in How to tub a ute Slydog style.
Make it removable Rob, 4mm sheet alum with Dzus clips holding it in.
-
Defective reacted to slydog in How to tub a ute Slydog style.
OK thought seeing as I got a few questions about this tub job on my ute I may aswell put it out there for all to see In the hope that it may inspire some to do a similar job on there's with some tips from here there every where.
Start with wheels not ideas.Wheels can be put on a car and measured,ideas can't so be prepared for bad news.In my case I wanted atleast 50mm inboard to fit safely and allow for a bit more tyre at a later date if needed.So fitted the wheels,cut the tubs out and took some measurements and found the diff was 15mm out of square to the right!No wonder it stuck out...
Right side
Left side
Next step was cutting floor pan out
This happened in 3 stages
Got a feeling the cutting isn't done yet either.So onto the steel to make it work.I got some 100x50x3.2 wall RHS some 50x50x4mm RHS and some 5mm plate.
Next is measurements...
-
Defective got a reaction from JETFTR in Simmons website?
Lol at comparing quality three piece rims, available in whatever offset and size you want, to some stock 1980s alloys...
-
Defective got a reaction from JETFTR in Simmons website?
Lol at comparing quality three piece rims, available in whatever offset and size you want, to some stock 1980s alloys...
-
Defective reacted to rswepn in Simmons website?
I have seen the rip off simmons on a friends car...they look the same but have less nuts around the outer rim.
-
Defective reacted to Thom in AU Trans with no computer?
I just thought of something, ea series one ran a borg Warner 40 behind a 3.9 (the difference between Au and e series Bellhousings is covered in my 4.0l thread) so you can go 3 speed and it will bolt to an Au engine (an xflow one won't though
-
Defective reacted to GspecZL in AU Trans with no computer?
i would imagine you could manualise it. I think i read that. But then why have the auto. I wanna be lazy!
-
Defective reacted to Thom in AU Trans with no computer?
Ea trans computer, map,sensor, tps and Speedo sensor are required to run a btr stand alone
-
Defective got a reaction from revhead in AU Trans with no computer?
The early eb's (I think) used a standalone trans controller, would control an au trans just as well I would imagine.
Gotta be the easiest way to run a btr in a xfalcon.
-
-
Defective reacted to PSI_LTD in my car spat another pushrod today
dizzy I hope your car is a manual. dropping the auto in second to slow down will kill it soon