Leaderboard

You'll need a xflow t5 bellhousing, 4.0l are different to xflow

I was suspect of this idle switch when I tried to twist the vacuum hose off and noticed that the plastic could turn in the metal body, which made me realise that it is probably no longer hermetically sealed and either not working at all or only partially... I feel like I'm getting a better understanding of these carbs now and will have a go at giving it a new lease of life. I've owned my 89' van since 99' and it has only recently begun to run differently. For a while I was running E10 which made it run beautifully, but now I wouldn't recommend it (for those who don't know, E10 is terrible for diaphragms) which is most likely the reason for the demise of my diaphragms... All in all, my van has been a very reliable daily for me over the years! Go the Blue Oval!

I have the chance/option to buy an E-SERIES gearbox, A T5, I want to put in my XF, do I just change BELL HOUSINGS and fit, nothing else to do..it all lines up?

If you xf already has a t5 it's almost a straight swap, the trans mount is different on e series, ,e series has a single bolt trans mount, all you have to do is drill you crossmember for the e series mount and swap your speedo transducer, the rest its the same

The XF is a manual, T5, I was hoping to just put my XF BELL HOUSING on to the E SERIES GEAR BOX and put it into the car..use my gear stick on it..its UNLEADED, SO THE CABLE RUNS TO THE PASSENGER SIDE..

Yes Dean, the first pic certainly wasn't clear on that. As I have read so much stuff on the subject, I couldn't remember where I had seen the info relevant to my question...so with your prompting I went back to Dave's thread and found it again.