eattsie9 350 Posted November 3, 2014 Hey guys hoping u guys have some suggestions coz I'm fkn stumped... Just changed the wheel bearings for the Ed diff I've just fitted to my xf, anyway for some reason the drivers side axle doesn't seem to go all the way in. The axle sits out slightly and it isn't in snug (may b coz it's not all the way in). I have tried the shorter axle in both sides for curiosity sake and it fits snug and how I would have expected it too. Axles is in as far as it can go it turns drive shaft wit is still poking out a little bit Thanks Share this post Link to post Share on other sites
Stevemack 122 Posted November 3, 2014 Maybe the bearing isnt pressed home completely Share this post Link to post Share on other sites
93xf 2 Posted November 3, 2014 Have you tried rotating the opposite axle back and fourth? I had a similar issue, moved the opposite axle around and it went in snug. Share this post Link to post Share on other sites
eattsie9 350 Posted November 3, 2014 Will give the wriggling a go tomorrow Share this post Link to post Share on other sites
slydog 7,873 Posted November 4, 2014 Could be bent too...may need to try the axle rotated a 3 or so splines @ a time till it goe's all the way home...and sometimes they need to be done up to take up the last bit of slack in em. 1 XTREME KARTS XF reacted to this Share this post Link to post Share on other sites
eattsie9 350 Posted November 4, 2014 Got it in today thanks for the help, rotated it a bit then rocked back n forth then Walla it went in 4 Outback Jack, 93xf, XTREME KARTS XF and 1 other reacted to this Share this post Link to post Share on other sites
Ando81 2,950 Posted November 6, 2014 Glad it worked for ya mate. Another simple yet time saving fix from the help of these ozfalcon legends! It's great to see everyone offering their hints and tips to help us all get the job done 3 XTREME KARTS XF, Outback Jack and eattsie9 reacted to this Share this post Link to post Share on other sites