XG ignition barrel and door locks

[Gaz 1,085]

I've always used a small flat screw driver and some gentle persuasion. A smack on the edge to create a dimple and then use that to tap it around. Once you've gone about 1/2 a turn it will be finger tight

[XFute-1JZsoarer 140]

That sounds simple, I'll give it a go.

Thinking I might wire the XF ign in just to test that it turns over and all that, then find a new one to put in properly.

Was kinda thinking of stashing the XF barrel under the dash somewhere and use a start button on the dash.

But that's just a thought at the mo.

[SLO247 1,713]

I think the plugs are the same for the switches. Just fit the smartlock bypass/j3 and plug in the xf ign switch. Done!

[XFute-1JZsoarer 140]

Awesome, thanks SLO247