jeza351 0 Posted June 18, 2013 Hi all I have a 351 Cleveland in my xe it was sitting for around 8 weeks without being started, starter motor issue. Anyway when I fired it up with New starter installed it started making a squealing noise was coming and going similar to a belt slipping can't be this only has Gilmer drive I noticed oil pressure had dropped off from what it used to run was fine when starter shit itself. Any ideas what could cause this I'm hoping it's not bearings or pump be my luck tho, motor has done approx 8 to 9 thousand since full rebuild any help appreciated hoping a oil change will do it oil seemed to be a little bit milky condensation on the dipstick but has been out in the weather Thanks for the help in advance Share this post Link to post Share on other sites
bear351c 10,277 Posted June 18, 2013 Where is noise coming from? Front or back of engine? What is current oil pressure? Is the starter motor exactly same as old unit? Some used a thin spacer plate. Without it, ring gear can just touch the teeth on the starter gear. Does it squeal when you rev it, or at idle? >10,000kays - shouldnt be anything major. Checked for Gerbils or mice ? Share this post Link to post Share on other sites
jeza351 0 Posted June 19, 2013 really hard to tell where exactly the squel is coming from it comes and goes on idle and with a rev but isnt consistant. havent had it running very much( no more than 4 or 5 minutes since the issue) it was running 70 psi on start up before now its lucky to get to 55 it is a different starter aswell i did think of the spacer for starter but the factpressure isnt what it was has me slightly concerned Share this post Link to post Share on other sites
ronny 204 Posted June 19, 2013 Could be the alt Get under bonnet and have a good listen while giving it a few revs at the carby Share this post Link to post Share on other sites
Stevemack 122 Posted June 19, 2013 I had a starter do this, the gear was just touching the flywhel, wrong starter type. 1 czy383 reacted to this Share this post Link to post Share on other sites
jeza351 0 Posted June 19, 2013 I'm gonna pull starter out on weekend and space it out, hope to hell that it's the problem Share this post Link to post Share on other sites