Campo

Who did that for ya?

Just run efi ya poof! Haha

Will need a bigger alt when i put my thermos on, keen to see a cheap but good way to do it!

Keen to see!

You're not wasting any time mate, looking good!

That looks good mate, pricy though!

What alternator should I be putting in?

Damn man, what a rip! Shoulda let me know, I just got a kit for myself from VPW last week, could have got one for you too!

Looks good mate!

I'm assuming they'll be pricey?

Hope so! I'd looooooove some gold centre fr17's!

Something about a bolt /plug on the drivers side near the back is the identifier isnt it?

Is there any easy way to tell the difference?

Have seem a lot about wet on wet painting, does it come up good enough? Would the base dry properly underneath?

Any idea which diff hats are different Thom? Also, Crazy, some diffs (EF-EL possibly from memory? Its e series for sure) have numerous holes to put the standard bottom arms in, which alters pinion angle also.

Got any pics or info on the rest of the car?

How you planning on keeping the sand/garnet clean and under control? Planning on recycling it like in an abrasive blasting cabinet?

Awesome mate, definitely sounds like the go! Will be speaking to you about ordering one very soon I hope

Hey mate, going to be needing a chip soon for my EF 4.0L engine that I'll be putting into my XF, what sorta figures am I looking at for the chip and software to tune it? Can it be programmed to disable smartlock and all that crap by me or do you have to do that? Also, can a chip be reprogrammed or is it a one use only kinda deal? Cheers

Send me a message with exactly what you're after mate

Heat gun is fine on about half temperature at about 6inches away. Dont need to get the sticker super hot, just warm.

If you need to source new pinstriping i can get onto it

Ah right that makes sense

The hiace/hilux has falcon stud pattern and stuff doesn't it? How does everyone else do the 5 stud conversion, modify a falcon diff?

Heat gun to help peel the striping off then use some prepsol or wax and grease remover to remove any left over glue residue. The paint under the stripe will be a fair bit brighter, depending how long it has been on there, so give the car a full cut and polish (what a good excuse to get it looking smick again!)