Bigbam 85 58 Posted October 4, 2014 Have the msd 6AL 2 ignition. Test for spark have power to msd. Just no power at coil? Share this post Link to post Share on other sites
slydog 7,873 Posted October 4, 2014 What wires are connected to the coil.Should only be Orange to positive and Black to Negative...? Share this post Link to post Share on other sites
Bigbam 85 58 Posted October 4, 2014 Orange and black are the only wires connected to dizzy. Wired in using hall effect trigger with tfi dizzy. Tried a est dizzy using points pickup. Also tried tfi with points and vice versa. Have got power at Msd. Good earth etc. Just not getting spark Share this post Link to post Share on other sites
slydog 7,873 Posted October 4, 2014 The pip signal wire should be connected to the white blue trace wire off the MSD...this is the Hall effects wire.Orange black should be connected to the COIL not dizzy... Share this post Link to post Share on other sites
Bigbam 85 58 Posted October 4, 2014 Sorry typo orange black are connected to coil. White, blue trace connected to dizzy. We checked everything, just dizzy wasn't triggering msd. Share this post Link to post Share on other sites
slydog 7,873 Posted October 4, 2014 Annnnnnnnnnd you replaced the sensor and it goe's now ? Share this post Link to post Share on other sites
Bigbam 85 58 Posted October 4, 2014 Sensor? Had to bail on it as had a bucks to go to. Also when mate pressure tested radiator had a small leak where the water pump got cut and welded up. So will get that fixed and try again next weekend Share this post Link to post Share on other sites