Free.51

I went to Jacob springs to get my fc rear leaves reset years ago cost $300 from memory but I think it would be probably $500 now.

I dropped the car off in the morning & it was finished in the arvo.

Well I rechecked everything & the passenger side loom for the window has no power but drivers side does so what do I do now

Might just unplug them & clean the pins on driver/passenger switches & see what happens

Or do u mean test it with the switch plugged into the loom still? (I haven't tried that).

Would the fault be at the drivers side switch for the pass.window or passenger side cos neither are working .

Yeah I put test light on the pin of the loom when I unplugged it from the actual switch & it lit up

Hi all as title says front pass window not working, noticed it on Friday so decided to investigate today the loom has power & I disconnected the elec motor plug put power to it from a battery & wires & window goes up & down fine I even used multiple sets of window switches thinking it might be a faulty switch but still no go i did the same on the drivers window switches too but nothing any ideas? dirty connection maybe?

Bumpers back on

Done..... Just need to smooth it out with a bit of 2000wd then clear coat & put hér back on the FD.not bad for spray cans.

I basically just followed ants instructions & sprayed it with flexi primer which is for plastics before using grey primer. I was just gonna clear coat it after all the colour is done.

Got the top painted today hopefully ill get the bottom painted tomorrow (platinum) th en clear coat it then bobs ur aunty

Ive done a few coats of flexi primer & a few of primer & sanded it with 400wd & 800wd & just washed the bar & is ready for paint but wont be doing it today maybe during the week.

Thanks heaps ants, ill continue with this next weekend

Ive sanded thé front bar on thé ltd using 120 & 240 grit it is very smooth & am wondering if i could just clean it up & start painting or would i need to add primer, re sand & then paint?

Pedders -

 

Rear Bump Stop / Kit

4360 Bump Stop-1pk

 

http://www.pedders.com.au/catalogue/ford/ltd/1982-1988-fd-fe

Thanks Dave i'll give them a buzz.

Just looked at thé nolathane website, it has every bush except rear shock bump stop .forme x series

Hi guys i wont to know if i can use ba-fg rear bump stops on my FD? Ive tried to get hold of x series ones but no luck unless i buy the shocks too. I saw these on eBay & thought i wonder if theyll work what do u guys think?

Me too.

Yeah, not much fun. Reckon i had to cut an 11mm ringy for the last bolt..

I don't think I had any problems fitting the drivers side extractor on my clevo which has 4 into 1 genies, only issue was I had to jack the front end up pretty high for clearance so I could manoeuvre the extractor into place & so the flange at the end wouldn't scrape on the ground.

Thanks fellas.

This might sound silly but what is the purpose of a sandwich plate?, is it like a gasket or to prevent dust getting in to the engine/trans.

Look at dis effie

Whoa, what a beauty dyllan.

Cheers fellas.

Hi guys I've noticed when I drive the Zl around for the for 30mins there's an annoying squeaking sound which only comes from the front right corner of the car but goes away after awhile any ideas on what might be causing it & how to stop it?