Fingers

AA series is one headlight above the other, AB is on an angle

There will be one big thing holding back the fully autonomous car... lawyers

A 120Y would never have kept up with you. A MK1 Escort out handles and out brakes a 120Y stock for stock. Your modified suspension may have contributed to you running out of brakes as your corner speeds would have been quicker.

A 120Y will do something similar, however the handling and braking are not in the same league.

Even 120Y's can cruise at 110

Yes, I may not have made it clear, but my comments were all towards forced induction of one sort or another.

I am not sure on this, so others in the know may shoot me down. That said, I have a little LPG knowledge. I have experience with gas, but not in a forced induction situation. ( Impco systems mostly) My thoughts would be to convert from the complex converter/simple mixer system fitted factory, and change to a simple converter/complex mixer system. A B2 converter and Gasresearch mixer is a known quantity with blow through LPG systems. It can be made work very well. Other people have had great results with Impco mixer and converter systems with forced induction. I have not done either, but I know a lot of people have with great results.

Zetec is the same bellhousing bolt pattern as the Kent. 2.0 blacktop with a C3, cheap as That said, if performance isn't an issue, 1600 Kent with the C3, no hassles

Older style pump with larger pulley seems to be win - win situation

Using Gerg's rule of thumb, maybe Emily is going to build a 325 hp crossflow?

Good to hear

Check the condition of the belts also. Look for cracks on the inside in particular. A broken belt can really wreck your day.

I think it would be more likely to be the alternator belt, rather than the steer belt. The steer belt is under very little load unless you are turning, whereas the alternator starts charging at a high level immediately on start to recover the charge lost while cranking, then reduces charge rate. That said, it would pay to check all belts. What is the car, what engine?

Offset grind and use small journal SBC 6" Carillo rods or similar.

XT and XW had them, but everything else 100%

And that's the great thing about a turbo

More than my old F350 requires

One comment, I doubt the Aussiespeed 4 barrel manifold will fit in a RHD F series. Brake master looks too close.

not home yet...

That was quick! I will try to get some photos when I get home today

I have a 300, it's in my '72 F350. Yes they are long and tall. I can take photos or measurements if anyone wants.

Or they were never fitted in the first place