Joelxf92
Members-
Content Count
97 -
Joined
-
Last visited
Content Type
Profiles
Forums
Calendar
Everything posted by Joelxf92
-
Thanks guys I might look into getting it rebuilt with some goodies Cheers Joel!!
-
Ok I'll admit I do a few skids and drifts on the grass and on the road the LSD used to throw me side ways easy when Turing a corner now all it does is spin both wheels but than singles like a commo. When I'm on the wet grass the diff does alright doubles up but wines like a bitch is it on the out or pretty much rooted ? How much to rebuild if it's worth it ? Thanks guys Cheers Joel!!
-
So brake likes fit with disk breaks might look into it what's a good diff that will last if I flog it around corners and grass Hackies was gonna post a vid of my grass Hackies on private property wanna see lol ? Thanks mate Cheers Joel!!
-
Would've been scary mate lol!! Cheers Joel!!
-
So would it be cheaper to fit an e series LSD what's involved in doing that ? Cheers Joel!!
-
hey guys i need some help diagnosing a idling problem with my 1992 xf falcon ute (carb) when i set the timing it will never stay on the set mark or anything like that my father recons the timing chain or dizzy could be a tooth out. im thinking of replacing the dizzy leads spark plugs done the air filter. also gave it a coolant flush and engine flush alone with new filter and oil and coolant however doesn't run any better there seems so be abit of leaking around the top and middle plate on the carb might clean it with something and see if it comes back. I haven't searched for air leaks yet will do though. its really running rough at idle at about 600rpm if i yank on the steering wheel while foot on the brake it just about stalls itself its auto stock motor any help would be appreciated Cheers. Joel!!
-
Car intermittently cutting out, suspect elecy issue
Joelxf92 replied to XFChris's topic in Auto Electrics
Hey mate is the issue fixed Mate I hade really similar issues mine was the idle control solenoid to test it pull the wire off the solenoid and your motor should stall. If it doesn't your ICS could e buggered I took mine out and chopped the pin off and blew it out so nothing goes in to the carbie and she ran beautifully after that. Cheers Joel!! -
This made me check mine I was ready for a big mess since the has rust anyway but it's as clean as a whistle Cheers Joel!!
-
Mine must of been faulty cause as soon as I pulled it out and chopped the pin off all things started to work normal again as it's still running like a charm Cheers Joel!!
-
It stops fine haha I don't quite get what your asking sorry Cheers Joel!!
-
Ok I have pulled out the ICS (idle control solenoid) and held my thump up to the hole to seal it and it ran so much better so I found out the ICS was buggered so I chopped the little rod off put it back in the hole and she runs great better than ever Cheers Joel!!
-
Ok thanks. So that's for they type that don't have vacuum advanced timing. Mine doesn't so I will try shorting out the T terminal thanks mate. Cheers Joel!!
-
I have set the timing all to book spec. A little change but than it runs like crap again and yes I tighten the clamp back up Cheers Joel!!
-
Yer it's a 1992 all I can see it a electrical plug going to the dizzy. I was told it could be the idle control solanoid so I tested it. The guy said pull the connected off and the car should die again it did nothing at All Cheers Joel!!
-
Ok so it ran good for about an hours stalled at the lights took abit to start.
-
There is no vacuum hose all I can see is a plug with wires no vacuum hoses dizzy parts were dirty as a hookers mouth. Cleaned them up and it runs abit better at this point in time Cheers Joel!!
-
I seen that part I'm the book but wasn't sure I will try it this arvo thanks mate. My stupid mistake Cheers Joel!!
-
Is it the vacuum plug ? Is it on the dizzy ? Couldn't find one Cheers Joel!!
-
I found out it idles better when it's cold and idles worse when warm it wouldn't idle maccars this morning kept on stalling when I tried to put it into drive after starting it Cheers Joel!!
-
Thanks mate I have adjusted the rpm and the air mix Screw seems to do next to nothing. It fuel leaking from the top and middle plates ill take a picture tomorrow. We set it at the book spec and when I have her some juice she just had a massive flat spot did nothing and didn't even down change. Thanks again Cheers Joel!!
-
Just a reminder to check wheel arch area
Joelxf92 replied to binary-fuel's topic in Steering, Suspension and Brakes
Only reason I can't be bothered is because it's not being driven and it's being sorted out running wise. When I get the car in running order than I will replace the upper and lower ball joints. There not that fucked the rubber is just falling off still not that much play so they will be sweet as for a while. Cheers Joel!! -
Just a reminder to check wheel arch area
Joelxf92 replied to binary-fuel's topic in Steering, Suspension and Brakes
My lower ball joints are fucked and I haven't replaced them yet I know how to do it done it many times I just cannot be bothered ATM lol it's not a daily driven car also so fuck all the other bad comments dude do it your self just double check everything you do -
Changed the cluster to a digital dash convert on my xf ute fuel gauge was working fine now I replaced the seal on top of the fuel tank and now it's showing empty I just filled up the tank about 95$$ and still showing empty I was told the sender unit is made of glass inside so could've I broken the glass... Thanks for any help guys Cheers Joel!!
-
Is ethanol 98? Cheers Joel!!
-
Car intermittently cutting out, suspect elecy issue
Joelxf92 replied to XFChris's topic in Auto Electrics
I'm having similar problems if I post a video of the rough duel you guys recon you could help out Cheers Joel!!