car10001 52 Posted April 6, 2019 hijust a question. how do you remove rearvision mirror from a ba/bf to attach the camera mirror monitor replacement that part of it changes to a screen when power is put to it.are the ebay dual screen replacenent ones any good in quality? what about the parkmate ones or the ford ones for a ranger or something, will they fit where the ba/bf one was.can you get dual screen mirror monitors that fit a ba so you can have front camera on one half when parking and when you got trailer or van on the other side comes on?with the ones that clip onto the existing mirror is the quality good? are the ebay ones good? and do all the clip on mirror monitors have the auto dim?thanks for any information Share this post Link to post Share on other sites
Defective 1,692 Posted April 6, 2019 An xe Ghia is certainly a wise choice. Just don’t break the headlights as they’re hard to obtain and expensive. apparently a few drops of oil down inside the cam sync can alleviate the symptoms of a dying cam sync, but a new one is only $30-40 plus freight out of the states. But the profile ‘number’ is measured different to the rest of the numbers. Eg 245/60x15. whilst the ‘245’ and the ‘15’ are clear measurements the profile is a percentage of the width measurement. And that’s ignoring the whole mindfuck of using mm and inches in the same description... Clearly, oils ain’t oils. Sent from my iPhone using Tapatalk Share this post Link to post Share on other sites
car10001 52 Posted April 6, 2019 what about information for the questions asked for the cameras Share this post Link to post Share on other sites
HIKFRD 11 Posted September 23, 2019 On 4/6/2019 at 6:04 PM, car10001 said: what about information for the questions asked for the cameras On my AU the monitor (rear view mirror ) just clips onto the existing rear view mirror and has provisions for 2 cameras one activated by selecting reverse the other by turning the unit on Share this post Link to post Share on other sites