car10001 52 Posted June 4, 2018 hi just a question, what is the hard line for a e series ford made out of. is it steel tube or aluminium tube or stainless steel tube. if you need new tube to make new lines for a e series where would you buy the tube from. also have some lines out a ed to fit in a ef, they have in a section a small amount of surface rust but isnt much and hasent gone through and will probably sand off and clean up ok. would the ed lines fit a ef where the ef ones were which they should or would you have to run them seperately to rest of lines thanks Share this post Link to post Share on other sites
gerg 10,871 Posted June 5, 2018 Normally thin wall steel tube, zinc plated inside and out. Pre-bent from factory so don't try and bend it yourself or you'll squash it.Sent from my CPH1607 using Tapatalk Share this post Link to post Share on other sites
car10001 52 Posted June 6, 2018 also have some lines out a ed to fit in a ef, they have in a section a small amount of surface rust but isnt much and hasent gone through and will probably sand off and clean up ok. would the ed lines fit a ef where the ef ones were which they should or would you have to run them seperately to rest of lines Share this post Link to post Share on other sites