Jump to content
Server maintenance Read more... ×
ICEWOLF

Cleveland EFI temp sensor

Recommended Posts

Hey guys

Was wondering where the best location for my Holley sniper EFI temp sensor would be?

Holley instructions say:

"Must be installed in a coolant passage in either the intake manifold or cylinder head. Do not install in thermostat housing."

I presume that means neither of the 2 previous temp sensor locations will do? One was factory just below the thermostat housing and the other was a speco gauge in the water pump just below the heater hose

Share this post


Link to post
Share on other sites

Any coolant passage on the engine side of the thermostat will be fine.
Cold side of the termostat is no good, as it wont show engine temp until after the car has already reached operating temp (Thermostat opens at 80+ degrees C.)
The same place the heater hose comes from is a good option.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×