Search the Community
Showing results for tags '6 CYL'.
Found 1 result
-
Hey all, So I have wired my entire car and everything is work, within the next few days I'll be making my spark leads and doing the timing and hoping all goes well and the car starts. But first I need verification of my build, I have a MSD 6AL-2 PROGRAMMABLE; I need to stress its the programmable box, as people get confused and tell me I need the dizzy module and what not. So I have the box wired up, and a MSD Blaster SS Coil Pack, I then have an XF electronic dizzy as shown in the pictures, I'm running it with no module as the Programmable box has a separate wire and setting for Electronic dizzies. I'll tell you how I have done it, so I have wired the wires from the box into the dizzy as the manual said, so there is a 12V wire going to the PWR plug of the dizzy, then there is a GRD wire coming from the dizzy, and then there is the WHITE/BLUE wire going the PIP signal wire of the dizzy, I then have the 12V ignition to the MSD and all the earthing done. So I turn the key to START, and the MSD boots up and I can read it off the computer so its all working, the settings up have been done and once I have the spark leads done up, I should be good to go. I just want you guys to confirm this wiring is correct, and it will work, I don't want to be chasing my tail here. Also, if you guys can confirm the order of the PINS internally on the dizzy are as follows, GRND, PWR, PIP (so that's looking up at the dizzy left to right) Will post pictures once photobucket is back up and running Thanks everyone.
