Jump to content

GreekStallion

Members
  • Content Count

    4
  • Joined

  • Last visited

About GreekStallion

  • Rank
    Newbie

Profile Information

  • Location
    Sydney, NSW
  1. GreekStallion

    Holley Sniper EFI

    The fuel system is whats keeping me at bay. I'd prefer the surge in the boot, so I'm looking at finding a small electric pump that will act as a lift into a surge. Currently asking Holley about their Mighty Mite pumps as they are self regulating, so hopefully no need for a full return line. Last time I touched the fuel tank, the sender wouldn't seal and leaked fuel constantly. Still have nightmares about that.
  2. GreekStallion

    Holley Sniper EFI

    Very interested in this, as I was ready to pull the trigger and buy the 4 barrel version to eventually boost it.
  3. GreekStallion

    Au falcon running rough

    I completely forgot I posted this. It turns out that one of the leads and the coil pack had gone almost simultaneously.
  4. GreekStallion

    Au falcon running rough

    Hi all, I've got a AU XR6 VCT which is running rough on ide and driving. I'm not the most mechanically minded, so i'll try explain the best I can. Cold idle, it is very rough, sometimes rough enough that you can feel it in the drivers seat. When it warms up, its a lot better. There is a sucking sound coming somewhere underneath the throttle body when I switch ignition off. But I cant be sure as it could be the throttle body itself. There also seems to be a sort of dripping sound when you sit in the car (sort of like a slow tap leak on a metal sink) Shifting into either Drive or Reverse, the engine runs rougher than Park or Netutral, especially at low speeds (<5kmh). While driving, it feel like the torque comes and goes in phases. If I raise the revs to ~1500, it will start poping every few seconds through the exhaust, and the popping will occur more often the more I push the motor. I am fairly certain there is a vacuum leak, but I havent yet managed to find it. I've used carby cleaner on the top of all the inlet pipes to try and test the gasket. I have also done an ECU fuel trim reset, which as far as I can tell, is only making it chug more fuel than usual. I have tested the resistances between leads through the common coil pack, and all seem to be normal. The car has had a full exhaust system done (inc extractors and hi-flow cat) a few days ago. Currently running 3 week old Mobil 98. Any assistance is greatly appreciated. Nick
×