-
Content Count
165 -
Joined
-
Last visited
About xe1984
-
Rank
Advanced Member
Recent Profile Visitors
2,384 profile views
-
I know it looks like that
-
xe1984 reacted to a post in a topic: anyone know xe v8 air cleaner paint code?
-
*xd xe
-
Just looking for the name or paint code of the xf xe silver aircleaners
-
If there enkei they will light as wheels.. I had a set of oldshool eknie 15x10 with tyres and they were like the lightest car wheel I have ever picked up
-
Yeah I reckon use are right 31 spline axles it is!
-
Thanks slydog I might have to get them. Or would it be cheaper convert the centre to 28 spline and have it rebuilt same time.
-
Hey guys I've got an Xe 9 inch diff housing that came with 28 spline axels. One is around 800 mm and the other one Is around 700 mm. I'm just wondering would these sizes be readily available in 31 spline ? Because I have a 31 spline 9 inch diff centre sitting here, or should I have the diff centre changed to 28 spline? What do you guys think is easier, better and cheaper ? Cheers guys
-
Just make you get tdc on the compression stroke not the exhaust stroke
-
hey I somehow got that going too by holding the button while driving.
-
. Yeah I want to have the converter checked as well but I think I have resolved by just going on a big hwy drive just then and I have got it down to 13.7L/100km on avg but before I left it was showing 60L/100kms on avg, so I think the computer was confused for a bit. Cause even after the hwy I drove back streets and couldn't get it to go over 15L/100kms on avg so was just the computer been a dick till I took on a hwy drive for awhile. And it only did this when I changed the o2 sensor and that must of done something to because the best it ever showed before I changed that was 17L/100kms I think.
-
The gas gauge is connected up with the normal fuel gauge and seems the showing the right amount of gas I'm putting into it. Is that the gauge you mean?
-
. Take it out n move it back a gear
-
Is it 180 degrees out? I put a mini extension bar with tape around it and shove it in the spark plug hole and crank it. And when it goes flying I know I got top dead center on the compression stroke. I might be a dick for doing that but it works.
-
Well I'm glad I replaced the last o2 sensor it was absolutely f#cked when I pulled it out.