ltdute

shit actually I think mine is an EB one, not sure if they are the same

yeah mate just got to re drill the two bolt holes that hold it on, its what I have on mine. the xf's is a throttle position "switch" not a sensor which is why it wont be working with your MS

thanks for your help again noobus those pics are gold, just what I was after. cheers for your help guys shouldn't be far off getting the old girl going, with all you guys help its much appreciated

sounds dodgy but can i file away some of the body of the injector so that it fits in further?? the factory injector pushes right into where it goes wider but the xr6 injector will only push in about 5-10mm

factory injector next to the xr6 injector

hey guys as the title says......anyone actually done it? I am attempting it at the moment after being told they are all universal fit but they don't appear to fit well. eg. only just sit into the manifold on the engine side. they are the same length from rubber seal to rubber seal as the factory injectors so they do fit in and bolt up etc. but they are really only just sitting in there on the engine side which gives me the shits if its not sealed properly. any ideas?? failing that any ideas on some injectors that will fit?? and where to purchase them from bearing in mind its for a turbo xflow so I was wanting around 36lb to 44lb

cheers guys. I was hoping someone had some bright idea on removing that plastic ring.......

cheers guys. so would I be correct in saying I can unplug it and remove it all? I don't have the EGR hooked up

My guess is its something to do with the cruise control? as theres a heap of vacuum lines running out from under. So next question is if I do away with the cruise control can I just remove the plug from here and get rid of all that ugly sheeit?

Hey guys can anyone point me in the right direction on how to replace the fuel pump in my efi xf? I get the basics but im sure I have seen a "how to" guide before but may have been on the "other" forum?? cant seem to find it in the search now tho.... I have a walbro to put in as replacement

Anybody still running aircon with their turbo xflows? In the process of fitting everything up now and the aircon unit and all its pipes look as if they are going to be in the way. If possible I would like to keep the aircon. Its an 87 xf ghia. also would the heat affect the aircon pipes? they are already factory heat wrapped

hey nzxd can I have the nz supplier too please?

good point xfghia747 cheers for your help

reason i want to front face it is I have stuck my wastegate right in the way.......... so figure its a good excuse to shorten the intercooler piping sorry for the blurry photo pretty crap lighting in my shed

I do realise that its not an ideal inlet manifold but I can make this for nothing and it should run while I sort out a custom plenum, so long as number 6 cylinder doesnt run too lean