Leaderboard
Popular Content
Showing content with the highest reputation on 08/16/2020 in all areas
-
4 pointsNah it's where a plastic clip goes that holds the vacuum line for the hot air snorkel actuator. That vac line goes off to a ported vacuum switch, probably on the thermostat housing. Sent from my CPH1920 using Tapatalk
-
3 points
CLEVELAND AIR CLEANERS
deankxf and 2 others reacted to SPArKy_Dave for a post in a topic
That square hole is for a plastic clip, which holds the vacuum lines running to the valve. edit - gerg beat me to it... I concur with the above. -
1 point
CLEVELAND AIR CLEANERS
CHESTNUTXE reacted to dvfalcon for a post in a topic
Chestnut Not to sure whether to weld up or not, where do you get your wing nuts from to hold on the lid? -
1 pointdoes the mesh filter breather thing clip in to that. or is it for vacuum lines clip? been a long time since i've seen a stock clevo
-
1 point
CLEVELAND AIR CLEANERS
dvfalcon reacted to CHESTNUTXE for a post in a topic
yes xd and xe have thhat hole,not sure what it does but looks like a small square support or something,very interesting. -
1 point
CLEVELAND AIR CLEANERS
CHESTNUTXE reacted to dvfalcon for a post in a topic
Forgot to load photo Sent from my iPhone using Tapatalk -
1 point
CLEVELAND AIR CLEANERS
CHESTNUTXE reacted to dvfalcon for a post in a topic
Welding up some ex gas mixer holes to put on my car today and notice this hole/slot what is it for thx Dale -
1 pointNext to the waterpump on a clevo is for the temp sensor that goes to the dash, The threaded hole on top of the thermostat housing is 3/8" Gas, Tridon thermo fan switch will fit straight into there, A TFS110 will turn fans on at 85°C & off at 80°C & TFS111 is on at 95°C & off at 90°C. simply run the ground wire from the relay to the TFS. I run this on the Clevo my Black ute
